Driver Side: Seatback: Assembly

Assembly is in the reverse order of disassembly.

Install new hog rings on the seatback trim in original positions.

Courtesy of NISSAN NORTH AMERICA, INC.
Use only one hog ring in each designated location.
Make sure hog rings are correctly fastened around both the seatback trim and seat frame.
Use NISSAN standard hog rings and tools to assemble.
Smooth out all wrinkles during assembly.

CAUTION:

When installing the front side air bag module, make sure the inner cloth (reinforcement cloth) is not caught in a bolt hole.
Do not reuse the front side air bag module nuts.
Do not tighten the front side air bag module nuts twice (prevent improper torque).
Do not damage the front side air bag module harness.
Always route side air bag module harness in original location. Replace any deformed or damaged clips with the same type and color. Always install clips in the original location in the harness.
After installation is complete, check that no system malfunction is detected causing the air bag warning lamp to illuminate.
If a malfunction is detected by the air bag warning lamp after repair or replacement of the malfunctioning parts, perform the SRS FINAL CHECK. Refer to SRS Final Check .