Work Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX50. However, it is still accessible from the selected car via links, so may be relevant.

VEHICLE CONDITION CHECK
1. Park the vehicle in the straight-forward position.
2. Unload the vehicle (no passenger aboard).
GO TO 2.
SENSOR INITIALIZE
CONSULT
1. Press push-button ignition switch to ON.
2. Select "LEVELIZER ADJUSTMENT" in "Work Support" mode of "ADAPTIVE LIGHT".
3. Touch "Start".
4. When "INITIALIZE COMPLETE", touch "End".
  NOTE: If "INITIALIZE NOT DONE" is indicated, AFS control unit detects that the height sensor signal changes. The sensor initialize is cancelled. In this case, press push-button ignition switch to OFF to prevent the vehicle from the height change. Perform the sensor initialize again.
Is the sensor initialize completed?

YES

GO TO 3.

NO

Perform the sensor initialize again.
SELF DIAGNOSTIC RESULT CHECK
CONSULT
1. Select "Self Diagnostic Result" mode of "ADAPTIVE LIGHT".
2. Check DTC.
Is DTC detected?

YES

GO TO 2.

NO

Work End.