LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> Altima SL, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Brake System) >> Unit Disassembly And Assembly >> Rear Disc Brake >> Disassembly and Assembly >> Assembly

Disassembly and Assembly: Assembly

WARNING: This page is about a different car, the 2020 Infiniti QX50. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bleeder valve and cap. Refer to Exploded View .
  2. Apply brake fluid to the piston seal (1), and install the piston seal to the brake caliper body.
    GNSJPFIA0039Z-039Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse the piston seal.
  3. Apply grease to the piston boot (1). Apply brake fluid to the piston (2). Cover the piston end with the piston boot, and then install the cylinder side lip on the piston boot securely into the groove on the brake caliper body.
    GNSJPFIA0040Z-040Courtesy of NISSAN NORTH AMERICA, INC.
  4. Push the piston (1) into the brake caliper body by hand and push the piston boot (2) piston side lip into the piston groove.
    GNSJPFIA0041Z-041Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Press the piston evenly and vary the pressing point to prevent the cylinder inner wall from contact.
  5. Apply grease to the bushing.
  6. Install the bushing to the slide pin.
  7. Apply grease to the slide pin boots and the slide pins.
  8. Install the slide pin boots and the slide pins to the torque member.
  9. Install the brake caliper to the vehicle. Refer to Removal and Installation .
scientia non olet · About LEMON Manuals