Work Procedure: Description
WARNING: This page is about a different car, the 2020 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
Always perform the RCTA system action test to check that the system operates normally after replacing the side radar LH/RH, or repairing any BSW/RCTA system malfunction.
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.
CAUTION:
Fully understand the following items well before the road test;
- Precautions: Refer to PRECAUTION FOR INTELLIGENT BLIND SPOT INTERVENTION SYSTEM SERVICE : Precautions .
- System description for RCTA: Refer to System Description .
- Normal operating condition: Refer to Handling Precaution .
- CHECK BSW/RCTA SYSTEM SETTING
- Start the engine.
- Check that the BSW system setting can be enabled/disabled through the vehicle information display.
- Turn OFF the ignition switch and wait for 30 seconds or more.
- Check that the previous setting is saved when the engine starts again.
GO TO 2.
- ACTION TEST FOR RCTA
- Enable the setting of the RCTA system through the information display.
- Check the RCTA operation according to the following table:
Vehicle condition
Action
Buzzer
- R range
- 5 MPH (8 km/h)
If the radar detects an approaching vehicle from the side.
- Chime sound (single beep)
- Flashes Blind Spot Warning indicator on the side of the approaching vehicle is detected.
- Yellow rectangular frame appears in the display.
Single beep
No approaching vehicle
No action
--
Inspection End.