Work Procedure
WARNING: This page is about a different car, the 2020 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
Each function is reset to the following condition when the driver seat control unit is replaced.
|
Function |
Condition |
Procedure |
|
Memory (Seat, door mirror) |
Erased |
Perform storing |
|
Entry/exit assist |
ON |
Perform initialization |
|
Set slide amount *1 |
||
|
Intelligent Key interlock |
Erased |
Perform initialization |
|
Perform storing |
*1 : Default value is 40 mm.
NOTE:
Notice that disconnecting the battery when detected DTC are present will erase the DTC memory.
- SYSTEM INITIALIZATION
Perform system initialization. Refer to Work Procedure .
GO TO 2.
- MEMORY STORAGE
Perform memory storage. Refer to Work Procedure .
GO TO 3.
- LOG-IN STORAGE
Perform memory storage. Refer to System Description .
GO TO 4.
- SYSTEM SETTING
Perform system setting. Refer to Work Procedure .
Inspection End.