Component Parts Location

Courtesy of NISSAN NORTH AMERICA, INC.

No.	Component	Function
1.	CVT shift selector (park position switch)	CVT shift selector detects the shift lever status and transmits park position switch signal status to the Intelligent Key unit.
2.	Transmission range switch (with CVT)	Supplies power to the starter cut relay (inside IPDM E/R) when the CVT shift selector is shifted into the P or N position.
3.	Park/neutral position (PNP) switch (neutral switch) (with MT)	Park/neutral position (PNP) switch (neutral switch) detects that the Transmission is in the neutral position, and transmits the signal to the BCM.
4.	IPDM/ER	IPDM E/R detects hood open/closed signal and controls horns when horn chirp is required.
5.	ECM	ECM Sends transmission gear position to the BCM.
6.	Stop lamp switch	Stop lamp switch detects that the brake pedal is depressed, and transmits the signal to the BCM. Refer to Stop lamp switch .
7.	BCM	BCM controls the door lock actuators.
8.	Clutch pedal position switch (with MT)	Clutch pedal position switch detects that the clutch pedal is depressed, and transmits the signal to the BCM.
9.	Clutch interlock switch (with MT)	Clutch interlock switch detects that clutch pedal is depressed, then provides power source to starter control relay and starter relay, and transmits ON/OFF signal to BCM.
10.	Combination meter	Combination meter transmits the vehicle speed signal to BCM via CAN communication. BCM also receives the vehicle speed signal from ABS actuator and electric unit (control unit) via CAN communication. BCM compares both signals to detect the vehicle speed. Security indicator lamp is located on combination meter. Security indicator lamp blinks when ignition switch is in any position other than ON to warn that NISSAN VEHICLE IMMOBILIZER SYSTEM-NATS [NVIS (NATS)] is on board.
11.	NATS antenna amp.	ID verification is performed between the BCM and the transponder integrated into the key via the NATS antenna amp.