LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2020 >> Sentra S >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Electronic Control Modules (Service Information)) >> Module, Radio/Entertainment Telematics >> Removal And Installation >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Fiat 124 Spider. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the lower right instrument panel trim. Refer to PANEL, INSTRUMENT PANEL TRIM, REMOVAL AND INSTALLATION .
    GC0175530Courtesy of CHRYSLER GROUP, LLC
  3. Using trim stick C-4755 or equivalent, remove the center trim bezel (1b) from the instrument panel.
    GC0176182Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the wiring harness connector (1).
    GC0176189Courtesy of CHRYSLER GROUP, LLC
  5. Remove the screw (1a) for the radio assembly (1b).
    GC0176033Courtesy of CHRYSLER GROUP, LLC
  6. Pull out the radio assembly from the instrument panel (1a), releasing the retaining clips (1b) of the display trim.
  7. Disconnect the wiring harness connectors (2a) and remove the radio assembly (1a).
  8. If required, remove the radio display from the Radio/Entertainment Telematics Module (ETM). Refer to DISPLAY, RADIO, REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals