Inspection Procedure
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.
CAUTION:
Fully understand the following items well before the road test;
- Precautions: Refer to Precaution for Blind Spot Warning System Service .
- System description for Blind Spot Warning: Refer to System Description .
- Normal operating condition: Refer to Description .
- CHECK BSW SYSTEM SETTING
- Start the engine.
- Check that the BSW system setting can be enabled/disabled on the integral switch.
- Turn OFF the ignition switch and wait for 5 seconds or more.
- Check that the previous setting is saved when the engine starts again.
GO TO 2.
- BSW SYSTEM ACTION TEST
- Enable the setting of the BSW system on the integral switch.
- Check BSW operation according to the following table:
Vehicle condition/ Driver's operation
Action
Vehicle speed
(Approx.)
Turn signal condition
Status of vehicle detection within detection area
Indication on the
Blind Spot Warning indicator
Indication on the combination meter
Indicator color
Buzzer
Less than approx.
18 MPH (29 km/h)
--
--
OFF
ON
White
OFF
Approx.
20 MPH (32 km/h)
or more
--
Vehicle is absent
OFF
ON
White
OFF
OFF
Vehicle is detected
ON
ON
White
OFF
ON
(vehicle detected direction)
Before turn signal operates
Vehicle is detected
Blink
Blink
Yellow (Blink)
Short continuous beeps
Vehicle is detected after turn signal operates
Blink
Blink
Yellow (Blink)
OFF
Inspection End.