DTC Diagnosis Procedure
- CHECK ENCODER POWER SUPPLY CIRCUIT
- Power switch OFF.
- Disconnect the parking actuator connector.
- Check the voltage between parking actuator vehicle side harness connector terminal and ground.
Parking actuator
Ground
Condition
Voltage
(Approx.)
Connector
Terminal
F4
9
Ground
Power switch ON
5 V
Is the inspection result normal?
YES
GO TO 2.
NO
GO TO 4.
- CHECK HARNESS BETWEEN VCM AND ENCODER
- Power switch OFF.
- Disconnect the VCM connector.
- Check the continuity between VCM vehicle side harness connector terminals and parking actuator vehicle side harness connector terminals.
VCM
Parking actuator
Continuity
Connector
Terminal
Connector
Terminal
E62
114
F4
3
Yes
113
5
138
8
- Check the continuity between VCM vehicle side harness connector terminals and ground.
VCM
Ground
Continuity
Connector
Terminal
E62
114
Ground
No
113
138
Is the inspection result normal?
YES
GO TO 3.
NO
Repair or replace damaged parts.
- CHECK INTERMITTENT INCIDENT
Refer to Inspection .
Is the inspection result normal?
YES
Replace the reduction gear due to malfunction in the encoder (parking actuator). Refer to REDUCTION GEAR : Removal & Installation .
NO
Repair or replace damaged parts.
- CHECK HARNESS BETWEEN VCM AND ENCODER
- Power switch OFF.
- Disconnect the VCM connector.
- Check the continuity between VCM vehicle side harness connector terminal and parking actuator vehicle side harness connector terminal.
VCM
Parking actuator
Continuity
Connector
Terminal
Connector
Terminal
E62
88
F4
9
Yes
- Check the continuity between VCM vehicle side harness connector terminals and ground.
VCM
Ground
Continuity
Connector
Terminal
E62
88
Ground
No
Is the inspection result normal?
YES
Replace the VCM due to malfunction in the electric shift control module built in VCM. Refer to VCM : Removal & Installation .
NO
Repair or replace damaged parts.