Work Procedure

INITIALIZE TCM
With CONSULT
1. Set parking brake.
2. Turn ignition switch ON.
3. Select "Work Support" in "TRANSMISSION".
4. Select "ERASE MEMORY DATA".
5. While maintaining the conditions below, touch "Start".
  - Vehicle stop status
  - With engine stopped
  - Selector lever: "R" position
  - Accelerator pedal: Depressed
NOTE: Select "Start" and complete within approximately 20 seconds.

Is "COMPLETED" displayed?

YES

GO TO 2.

NO

Turn the ignition switch OFF and wait for a minimum of 10 seconds then perform the work again.

CHECK AFTER TCM IS INITIALIZED

With CONSULT

Turn ignition switch OFF with the selector lever in "R" position and wait for 10 seconds or more.
Turn ignition switch ON with the selector lever in "R" position.
CAUTION: Never start the engine.
Select "Special function" in "TRANSMISSION".
Select "CALIB DATA".

Check that indicated value of "CALIB DATA" is equal to the value shown below in the following table.

Item name	Display value
GAIN PL	0
GAIN LU	0
GAIN HC/RB	0
GAIN PRI	0
GAIN L/B	0
Gain secondary pressure sen	0
OFFSET PL	0
OFFSET LU	0
OFFSET HC/RB	0
OFFSET PRI	0
OFFSET L/B	0
Offset secondary pressure sen	0
MAP NO PL	0
MAP NO LU	0
MAP NO HC/RB	0
MAP NO PRI	0
MAP NO L/B	0
Map No. secondary press sen	0
OFFSET2 PL	0
OFFSET2 LU	0
Offset 2 high clutch sol valve	0
OFFSET2 PRI	0
OFFSET2 L/B	0
Offset 2 secondary press sen	0

Is the indicated value of "CALIB DATA" equal to the value shown in the table?

YES

GO TO 3.

NO

GO TO 1.

LOAD CALIBRATION DATA
1. Shift the selector lever to the "P" position.
2. Check that "P" is displayed on shift position indicator on combination meter.
  NOTE: Displayed approximately 4 - 5 seconds after the selector lever is moved to the "P" position.
Does shift position indicator display "P"?

YES

GO TO 5.

NO

GO TO 4.
DETECT MALFUNCTIONING ITEMS
Check the following items:
- Harness between the TCM and the ROM assembly inside the transaxle assembly is open or shorted.
- Disconnected, loose, bent, collapsed, or otherwise abnormal connector housing terminals
Is the inspection result normal?

YES

GO TO 1.

NO

Repair or replace the malfunctioning parts.
STORE CALIBRATION DATA
1. Turn ignition switch OFF and wait for 5 seconds.
2. Turn ignition switch ON.
Does the shift position indicator display "P" at the same time when turning ON the ignition switch?

YES

GO TO 6.

NO

Check harness between battery and TCM harness connector terminal.
ERASE THE CVT FLUID DEGRADATION LEVEL DATA
With CONSULT
1. Select "WORK SUPPORT" in "TRANSMISSION".
2. Select "CONFORM CVTF DETERIORTN".
3. Touch "Clear".
WORK END