Common Specifications & Procedures
370Z COMMON SPECIFICATIONS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SERVICE DATA | ||
| Torque | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION . | ||
| Axle Nut/Hub Nut | |||
| Front Hub Bearing Bolts | 65 Ft. Lbs. (88.3 N.m) | ||
| Rear Axle Nut & Hub Bearing Bolts | Rear Axle Nut: 74-77 Ft. Lbs. (100-105 N.m) Rear Hub Bearing Bolts: 65 Ft. Lbs. (88.3 N.m) |
||
| Battery | SERVICE DATA | ||
| Brakes | |||
| Bleeding Sequence | BRAKE FLUID | ||
| Disc Brakes | |||
| Front | FRONT DISC BRAKE | ||
| Rear | REAR DISC BRAKE | ||
| Torque | |||
| Front | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION . | ||
| Rear | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION . | ||
| Charging | |||
| Alternator | SERVICE DATA | ||
| Torque | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION . | ||
| Drive Belts | |||
| Adjustment | Vehicle equipped with auto-tensioner | ||
| Belt Routing | DRIVE BELT | ||
| Engine Cooling | |||
| General Service Specifications | SERVICE DATA | ||
| Radiator Cap Pressure | 11-14 psi (78.2-97.8 kPa, 8-1.0 kgf/cm2 ) | ||
| Thermostat R & I | WATER INLET AND THERMOSTAT ASSEMBLY | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | COMPRESSION PRESSURE | ||
| Oil Pressure | |||
| @ Idle | More than 14 psi (98 kPa, 1.0 kgf/cm2 ) | ||
| @ 2000 RPM | More than 43 psi (294 kPa (3.0 kgf/cm2 ) | ||
| Overhaul | SERVICE DATA | ||
| Torque | See Torque Specifications in text and applicable figures under REMOVAL & INSTALLATION | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate (Drive Plate) Torque | 65 Ft. Lbs. (88 N.m) | ||
| Fuel System | |||
| Fuel Pressure Release Procedure | FUEL PRESSURE RELEASE | ||
| Fuel Pressure | At Idle: Approximately 51 psi (350 kPa (3.57 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE CHECK | ||
| Fuel Filter Location | Fuel filter is attached to fuel Pump Unit located in fuel tank | ||
| Fuel Filter R & I | FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Engine is equipped with Coil On Plug ignition | ||
| Ignition Wires (Routing) | Engine is equipped with Coil On Plug ignition | ||
| Spark Plugs | |||
| Type | Denso FXE24HR11 | ||
| Gap | 0.043 in. (1.1 mm) | ||
| Tightening Torque | 14 Ft. Lbs. (19.6 N.m) | ||
| Starting | |||
| Starter | SERVICE DATA | ||
| Torque | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION | ||
| Wheel Alignment | |||
| Adjustment Specifications | |||
| Front | SERVICE DATA | ||
| Rear | SERVICE DATA | ||
| Torque | |||
| Front | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION | ||
| Rear | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 80 Ft. Lbs. (108 N.m) | ||