Work Procedure
- SAVING VEHICLE SPECIFICATION
CONSULT Configuration
Read out the vehicle specification from the old air bag diagnosis sensor unit and save the vehicle specification to CONSULT. Refer to "ECU setting" in the "CONSULT Operation Manual".
NOTE:- For the air bag diagnosis sensor unit, the Type ID is stored in CONSULT.
- The Type ID is the part number (vehicle specification) that is to be written to the air bag diagnosis sensor unit.
GO TO 2.
- REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
Replace air bag diagnosis sensor unit. Refer to DIAGNOSIS SENSOR UNIT : Removal & Installation .
GO TO 3.
- WRITING VEHICLE SPECIFICATION
Perform writing of the saved vehicle specification data according to the "ECU setting" procedure in the "CONSULT Operation Manual". Refer to Work Procedure .
GO TO 4.
- PERFORM ZERO POINT RESET
Perform zero point reset. Refer to Work Procedure .
END