Work Procedure
WARNING: This page is about a different car, the 2018 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
- WRITING VEHICLE SPECIFICATION
Perform writing vehicle specification.
When writing saved data
GO TO STEP 2 .
When writing manually
GO TO STEP 3 .
- PERFORM WRITING SAVED DATA
With CONSULT
- Turn ignition switch ON.
- Select "MULTI AV" of "Re/programming, Configuration" with CONSULT.
- Select "After ECU Replacement", of "Read / Write Configuration", and write the vehicle specification into display control unit.
WORK END
- PERFORM WRITING MANUALLY
- Turn ignition switch ON.
- Select "MULTI AV" of "Re/programming, Configuration" with CONSULT.
- Select "Manual Configuration", and write the vehicle specification to display control unit. Refer to Configuration List .CAUTION:
- Thoroughly read and understand the vehicle specification. ECU control may not operate properly if the setting is not correct.
- The "Setting Value" of this vehicle is as follows: Never select any other value than the setting value shown below. (If there is only 1 item in "Setting Value" that means that item is the only choice for this certain vehicle.)
WORK END