Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform Description .
4. Turn ignition switch ON.
5. Set selector lever to D position.
6. Check the voltage between ECM harness connector and ground.

   ECM			Condition		Voltage
   Connector	Terminal
   	+	-
   F25	105 (TP sensor 1 signal)	102	Accelerator pedal	Fully released	More than 0.36 V
   				Fully depressed	Less than 4.75 V
   	103 (TP sensor 2 signal)			Fully released	Less than 4.75 V
   				Fully depressed	More than 0.36 V

Is the inspection result normal?

YES

INSPECTION END

NO

GO TO 2.

Replace electric throttle control actuator. Refer to Exploded View .

INSPECTION END