Common Specs & Procedures
ARMADA COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Torque | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION | ||
| Axle Nut/Hub Nut | |||
| Front Axle Nut/Hub Bolts (4WD) | Axle Nut: 101 Ft. lbs (137 N.m) Hub Bearing Bolts: 107 Ft. lbs (145 N.m) |
||
| Rear Hub Nuts | Axle Nut: 135 Ft. lbs (182.5 N.m) Hub Bearing Bolts: 111 Ft. lbs (150 N.m) |
||
| Battery | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | |||
| Front | FRONT DISC BRAKE | ||
| Rear | REAR DISC BRAKE | ||
| Torque | |||
| Front | See Torque Specifications in text and applicable figures under FRONT DISC BRAKE | ||
| Rear | See Torque Specifications in text and applicable figures under REAR DISC BRAKE | ||
| Charging | |||
| Generator | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Torque | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION | ||
| Drive Belts | |||
| Adjustment | Drive belt tension is automatically adjusted by the drive belt auto tensioner. | ||
| Belt Routing | DRIVE BELTS | ||
| Engine Cooling | |||
| General Service Specifications | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Radiator Cap Pressure | 16 psi (110 kPa, 1.12 kgf/cm2 ) | ||
| Thermostat R & I | MULTI-WAY CONTROL VALVE | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | GENERAL SPECIFICATION | ||
| Oil Pressure | |||
| @ Idle | More than 14 psi (98 kPa, 1.0 kgf/cm2 ) | ||
| @ 2000 RPM | More than 43 psi (294 kPa, 3.0 kgf/cm2 ) | ||
| @ 6000 RPM | More than 57 psi (392 kPa, 4.0 kgf/cm2 ) | ||
| Overhaul | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Torque | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint" button. | ||
| Flywheel/Flex Plate (Drive Plate) Torque | 65 Ft. lbs (88.2 N.m) | ||
| Fuel System | |||
| Fuel Pressure Release Procedure | FUEL PRESSURE RELEASE | ||
| Pressure Specification | At Idling: Approximately 51 psi (350 kPa, (3.57 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE | ||
| Fuel Filter Location | In Tank Type | ||
| Fuel Filter R & I | FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Coil On Plug | ||
| Ignition Wires (Routing) | Coil On Plug | ||
| Spark Plug | |||
| Type | Standard Models: DILFR5A-11 FFV Models: DILFR5A-11D |
||
| Gap | 0.043 in. (1.1 mm) | ||
| Torque | Tightening torque: 18 Ft. lbs (24.5 N.m) | ||
| Starting | |||
| Starter | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Torque | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION | ||
| Wheel Alignment | |||
| Adjustment Specifications | |||
| Front | WHEEL ALIGNMENT | ||
| Rear | WHEEL ALIGNMENT | ||
| Torque | |||
| Front | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION | ||
| Rear | See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 98 Ft. lbs (133 N.m) | ||
| How To Use Nissan Service Information | |||
| Includes: Standard Bolt Torque Symbol Identification General Connector Info |
GENERAL INFORMATION | ||