Calibration Of DECEL G Sensor

CAUTION:

To calibrate the decel G sensor, make sure to use CONSULT.

(Calibration cannot be done without CONSULT).

ALIGN THE VEHICLE STATUS

Stop vehicle with front wheels in straight-ahead position.

GO TO STEP 2

PERFORM CALIBRATION OF DECEL G SENSOR
1. On the CONSULT screen, touch "Work support" and "DECEL G SEN CALIBRATION" in order.
2. Touch "Start".
3. After approximately 10 seconds, touch "End".
  NOTE:
  After approximately 60 seconds, it ends automatically.
4. Turn ignition switch OFF, then turn it ON again.
  CAUTION:
  Be sure to perform above operation.
GO TO STEP 3

CHECK DATA MONITOR
1. Run vehicle with front wheels in straight-ahead position, then stop.
2. Select "Data Monitor". Then make sure "DECEL G SEN" is within +- 0.08G.
Is the inspection result normal?

YES

GO TO STEP 4

NO

Perform calibration of decel G sensor again, GO TO STEP 1

ERASE THE SELF-DIAGNOSIS MEMORY

Erase the self-diagnosis memory of the ABS actuator and electric unit (control unit) and ECM.
- ABS actuator and electric unit (control unit): Refer to CONSULT FUNCTION (ABS) .
- ECM: Refer to CONSULT FUNCTION (VQ40DE) or CONSULT FUNCTION (VK56DE).
Are the memories erased?

YES

Inspection End

NO

Check the items indicated by the self-diagnosis.