LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2016 >> Leaf S >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Brake System) >> Unit Disassembly And Assembly >> Front Disc Brake >> Disassembly And Assembly >> Assembly

Disassembly And Assembly: Assembly

WARNING: This page is about a different car, the 2016 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install bleeder valve and cap.
  2. Apply rubber grease to piston seal (1), and install it to brake caliper body.
    Fig 1: Applying Rubber Grease To Piston Seal
    G05207993Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Do not reuse piston seal.

  3. Apply rubber grease to piston boot (1). Cover piston (2) end with piston boot, and then install cylinder side lip on piston boot securely into groove on brake caliper body.
    Fig 2: Applying Rubber Grease To Piston Boot
    G05207994Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Do not reuse piston boot.

  4. Apply brake fluid to piston (1). Push piston into brake caliper body by hand and push piston boot (2) piston side lip into piston groove.
    Fig 3: Applying Brake Fluid To Piston
    G05208009Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Press the piston evenly and vary the pressing point to prevent cylinder inner wall from contact.

  5. Apply Niglube Rx-2 grease to bushing; install bushing to slide pin.
  6. Apply Niglube Rx-2 grease to slide pin boots and slide pins.
  7. Install slide pin boots and slide pins to torque member.
  8. Install the brake caliper to the vehicle. Refer to REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals