LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2016 >> Altima Base >> Repair and Diagnosis >> Suspension >> Front Suspension >> Unit Disassembly And Assembly >> Front Coil Spring And Strut >> Disassembly And Assembly >> Disassembly

Disassembly And Assembly: Disassembly

  1. Install Tool (A) to the front suspension strut.
    Fig 1: Tool (A)
    G08688986Courtesy of NISSAN NORTH AMERICA, INC.
    Tool number (A) : ST35652000 (-)
    CAUTION:

    When installing Tool, wrap a shop cloth around front suspension strut to protect it from damage.

  2. Secure tool (A) in a vise.
  3. Install Tool to the strut rod.
    Tool number :-(J-49029)
  4. Slightly loosen the piston rod lock nut.
    WARNING:

    Do not remove the piston rod lock nut completely. If the piston rod lock nut is removed completely, the front spring can jump out and may cause serious damage or injury.

  5. Compress the front spring using a suitable tool (A).
    Fig 2: Compressing Coil Spring Between Spring Upper Seat And Lower Seat Using Spring Compressor
    G05224321Courtesy of NISSAN NORTH AMERICA, INC.
    WARNING:

    Make sure that the pawls of the suitable tool are firmly hooked on the front spring. The suitable tool must be tightened alternately so as not to tilt the front spring.

  6. Make sure the front spring is free between the strut mount bearing and the front spring lower rubber seat, then remove the piston rod lock nut.
  7. Remove the strut mount insulator and the strut mount bearing.
  8. Remove the bound bumper.
  9. Gradually release the suitable tool, and remove the front spring.
  10. Remove the front spring lower rubber seat.
scientia non olet · About LEMON Manuals