Power Supply Position Change Table By Push-Button Ignition Switch Operation

The power supply position changing operation can be performed with the following operations.

NOTE:

When an Intelligent Key is within the detection area of inside key antenna and when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
When starting the engine, the BCM monitors under the engine start conditions:
- Brake pedal operating condition
- Selector lever position
- Vehicle speed

Vehicle Speed: Less Than 4 Km/H (2.5 MPH)

Power supply position	Engine start/stop condition			Push-button ignition switch operation frequency
	With CVT		With M/T
	Selector lever position	Brake pedal condition	Clutch pedal condition
OFF → ACC	-	Released	Released	1
OFF → ACC → ON	-	Released	Released	2
OFF → ACC → ON → OFF	-	Released	Released	3
OFF → START ACC → START ON → START	P (Park) or N (Neutral)	Depressed	Depressed	1
Engine is running → OFF	-	-	-	1

Vehicle Speed: 4 Km/H (2.5 MPH) Or More

Power supply position	Engine start/stop condition			Push-button ignition switch operation frequency
	With CVT		With M/T
	Selector lever position	Brake pedal condition	Clutch pedal condition
Engine is running → ACC	-	-	-	Emergency stop operation
Engine stall return operation while driving	N (Neutral)	Released	Depressed	1

Emergency stop operation

Press and hold the push-button ignition switch for 2 seconds or more.
Press the push-button ignition switch 3 times or more within 1.5 seconds.