Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

1. CHECK FUSES AND FUSIBLE LINK
   
   

   Check that the following fuses and fusible link are not blown.

   Terminal No.	Signal name	Fuses and fusible link No.
   63	Battery power supply	12 (10A)
   70		G (40A)
   11	Ignition switch ACC or ON	18 (10A)

   Is the fuse blown?

   YES 

   Replace the blown fuse or fusible link after repairing the affected circuit.

   NO 

   GO TO STEP 2. 

2. CHECK POWER SUPPLY CIRCUIT
   
   
   1. Turn ignition switch OFF.
   2. Disconnect BCM connectors.
   3. Check voltage between BCM connector and ground.

      BCM		Ground	Ignition switch position
      Connector	Terminal		OFF	ACC	ON
      M20	63		Battery voltage	Battery voltage	Battery voltage
      	70
      M21	11	-	0 V	Battery voltage	Battery voltage

   Is the inspection result normal?

   YES 

   GO TO STEP 3. 

   NO 

   Repair harness or connector.

3. CHECK GROUND CIRCUIT
   
   

   Check continuity between BCM connector and ground.

   BCM		Ground	Continuity
   Connector	Terminal
   M20	65	-	Yes

   Is the inspection result normal?

   YES 

   Inspection End.

   NO 

   Repair harness or connector.