LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2015 >> Rogue SL, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Brake System) >> Unit Disassembly And Assembly >> Rear Disc Brake >> Disassembly And Assembly >> Assembly

Disassembly And Assembly: Assembly

WARNING: This page is about a different car, the 2016 Nissan Rogue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install bleeder valve and cap.
  2. Apply rubber grease to piston seal (1), and install it to the brake caliper body.
    Fig 1: Applying Rubber Grease To Piston Seal
    G05207993Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Do not reuse piston seal.

  3. Apply rubber grease to piston boot (1). Cover the piston end (2) with the piston boot (1), and then install cylinder side lip on the piston boot securely into the groove on brake caliper body.
    Fig 2: Applying Rubber Grease To Piston Boot
    G05207994Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Do not reuse piston boot.

  4. Apply brake fluid to piston (1). Push piston into brake caliper body by hand and push piston boot (2) piston side lip into the piston groove.
    Fig 3: Applying Brake Fluid To Piston
    G05208009Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Press the piston evenly and vary the pressing point to prevent cylinder inner wall from contact.

  5. Apply Niglube Rx-2 grease to bushing; install bushing to slide pin bolt.
  6. Install slide pin boots to torque member.
  7. Install the brake caliper to the vehicle. Refer to REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals