Diagnostic Test
- SAVE VCM DATA
- Turn off the power and wait at least 90 seconds.CAUTION:
During this period, never perform vehicle handling such as opening and closing of doors. If some kind of vehicle handling is performed, then wait another 90 seconds or more from the time of the vehicle handling.
- Turn power switch ON.
- Select "SAVE DATA FOR CPU REPLACE" in "WORK SUPPORT" mode using CONSULT.
- Follow the instruction of CONSULT display.NOTE:
Necessary data in VCM is copied and saved to CONSULT.
Is operation completed successfully?
YES
GO TO STEP 2 .
NO
GO TO STEP 5 .
- Turn off the power and wait at least 90 seconds.
- REPLACE VCM
- Turn off the power and wait at least 90 seconds.CAUTION:
During this period, never perform vehicle handling such as opening and closing of doors. If some kind of vehicle handling is performed, then wait another 90 seconds or more from the time of the vehicle handling.
- Replace VCM. Refer to REMOVAL AND INSTALLATION .
GO TO STEP 3 .
- Turn off the power and wait at least 90 seconds.
- PERFORM VCM KEY ID REGISTRATION
Refer to WORK PROCEDURE .
GO TO STEP 4 .
- WRITE VCM DATA
- Select "WRITE DATA AFTER REPLACE CPU" in "WORK SUPPORT" mode using CONSULT.
- Follow the instruction of CONSULT display.NOTE:
The data saved by "SAVE DATA FOR CPU REPLACE" is written to VCM.
Is operation completed successfully?
YES
GO TO STEP 9 .
NO
GO TO STEP 7 .
- REPLACE VCM
- Turn off the power and wait at least 90 seconds.CAUTION:
During this period, never perform vehicle handling such as opening and closing of doors. If some kind of vehicle handling is performed, then wait another 90 seconds or more from the time of the vehicle handling.
- Replace VCM. Refer to REMOVAL AND INSTALLATION .
GO TO STEP 6 .
- Turn off the power and wait at least 90 seconds.
- PERFORM VCM KEY ID REGISTRATION
Refer to WORK PROCEDURE .
GO TO STEP 7 .
- WRITE VIN DATA
Perform WORK PROCEDURE .
GO TO STEP 8 .
- LI-ION BATTERY ID REGISTRATION
Refer to "Li-ion Battery Registration Operation Manual".
GO TO STEP 9 .
- PERFORM ACCELERATE PEDAL CLOSED POSITION LEARNING
Perform WORK PROCEDURE .
GO TO STEP 10 .
- SET VCM TIMER
Models with navigation system: Perform WORK PROCEDURE (Navigation without BOSE) or WORK PROCEDURE (Navigation with BOSE).
Models without navigation system: Set the combination meter clock right. Refer to SYSTEM DESCRIPTION .
GO TO STEP 11 .
- CHECK DTC
- Turn off the power and wait at least 90 seconds.CAUTION:
During this period, never perform vehicle handling such as opening and closing of doors. If some kind of vehicle handling is performed, then wait another 90 seconds or more from the time of the vehicle handling.
- Turn power switch ON.
- Check DTC. If DTC is displayed, erase it.
END
- Turn off the power and wait at least 90 seconds.