LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2015 >> Frontier SL, 4WD >> Repair and Diagnosis >> Transmission >> Transfer Case >> Transfer: TX15B >> Precaution >> Precautions >> Precaution For Transfer Assembly And Transfer Control Unit Replacement >> Check 4WD Shift Indicator Pattern

Check 4WD Shift Indicator Pattern

  1. Set 4WD shift switch to "2WD", "4H", "4LO", "4H" and "2WD" in order. Stay at each switch position for at least 2 seconds.
  2. Confirm 4WD shift indicator lamp and 4LO indicator lamp change properly as follows.
    4WD shift switch  Indicator lamp  Operation of 4WD shift switch 
    4WD shift 4LO 
    2WD
    G08179989Courtesy of NISSAN NORTH AMERICA, INC.
    OFF 2WD → 4H switching can be done while driving. The indicator lamp will change when the driving mode is changed. Gear shifting between 2WD ==> 4H position must be performed at speeds below 100 km/h (60 MPH).
    4H
    GNSAWDIA0873ZZ-873Courtesy of NISSAN NORTH AMERICA, INC.
    GNSAWDIA0873ZZ-873Courtesy of NISSAN NORTH AMERICA, INC.
     
    Flashing
    For M/T models, to shift between 4H → 4LO, stop the vehicle and shift the transmission shift selector to the Neutral position with the clutch pedal depressed.
    4LO   For A/T models, to shift between 4H ==> 4LO, stop vehicle and shift transmission shift selector to the "N" position with brake pedal depressed.
    GNSAWDIA0873ZZ-873Courtesy of NISSAN NORTH AMERICA, INC.
    ON The 4WD shift switch will not shift to the desired mode if the transmission is not in "N" or the vehicle is moving.
    You must wait for the 4LO indicator lamp to stop flashing and remain lit or turned off before shifting your transmission into gear or releasing the clutch pedal.
    • If OK, the position between transfer assembly and transfer control unit is correct.
    • If NG, the position is different between transfer assembly and transfer control unit.

      Adjust the position between transfer assembly and transfer control unit. Refer TRANSFER POSITION ADJUSTMENT PATTERN .

      TRANSFER POSITION ADJUSTMENT PATTERN

      4WD Shift Switch Condition Refer Procedure
      4WD shift switch is in "2WD" when engine is stopped. "METHOD FOR ADJUSTMENT WITH 4WD SHIFT SWITCH AT "2WD""
      4WD shift switch is in "4H" or "4LO" when engine is stopped. "METHOD FOR ADJUSTMENT WITH 4WD SHIFT SWITCH AT "4H" OR "4LO""
      NOTE:

      Method of adjustment can be chosen voluntarily, according to location of 4WD shift switch.