Removal and Installation: Installation

Install the generator bracket (if removed), using the following procedure.
1. Temporarily tighten bolt (1).
2. Temporarily tighten bolt (2).
3. Tighten bolts (3) and (4) to specification in numerical order as shown below.
  
  Fig 1: Generator Bracket Mounting Bolts Tightening Sequence
  Courtesy of NISSAN NORTH AMERICA, INC.
  
  Tighten bolts (1) and (2) to specification.
Install generator using the following procedure.
1. Temporarily tighten the generator bolts in order from the lower to the upper.
2. Tighten the generator bolts to the specification starting with the top bolt.
3. Install "B" terminal harness and "B" terminal nut.
  CAUTION: Be sure to tighten "B" terminal nut carefully.
Install and check the tension of the drive belt. Refer to "REMOVAL AND INSTALLATION ".
Installation of the remaining components is in the reverse order of removal.