| IGN VOLT |
Ignition switch ON |
10 - 16 V |
| CONTROL MODULE MALF |
When chassis control module is normal |
Off |
| When chassis control module malfunction is detected |
On |
| CAN DIAG STATUS |
When diagnosis of CAN communication malfunction is detected |
Off |
| When diagnosis of CAN communication is normal |
On |
| STP LAMP OFF RELAY 1 |
Displayed but not used. |
- |
| STP LAMP OFF RELAY 2 |
Displayed but not used. |
- |
| ESS RELAY |
Displayed but not used. |
- |
| VEHICLE SPEED |
Vehicle Stopped |
0 km/h (0 MPH) |
| Driving |
Almost same reading as speedometer (within ±10%) |
| FR WHEEL SPEED |
Vehicle stopped |
0 rpm |
| Driving |
Increases according to vehicle speed |
| FL WHEEL SPEED |
Vehicle stopped |
0 rpm |
| Driving |
Increases according to vehicle speed |
| RR WHEEL SPEED |
Vehicle stopped |
0 rpm |
| Driving |
Increases according to vehicle speed |
| RL WHEEL SPEED |
Vehicle stopped |
0 rpm |
| Driving |
Increases according to vehicle speed |
| STEERING ANG SENSOR |
When driving straight |
0±3.5 deg |
| When steering wheel is steered to RH by 90° |
Approx. +90 deg |
| When steering wheel is steered to LH by 90° |
Approx. -90 deg |
| DECEL G SENSOR |
Vehicle stopped |
Approx. 0 G |
| When during acceleration |
Positive value |
| When during deceleration |
Negative value |
| SIDE G SENSOR |
Vehicle stopped |
Approx. 0 G |
| When right turn |
Negative value |
| When left turn |
Positive value |
| YAW RATE SENSOR |
Vehicle stopped |
Approx. 0 deg/s |
| When right turn |
Negative value |
| When left turn |
Positive value |
| ACCELE PEDAL POSITION |
When accelerator pedal is released |
0% |
| When accelerator pedal is depressed |
0 - 100% |
| THROTTLE CONTROL |
When electric throttle control actuator is normal |
NORMAL |
| When the electric throttle control actuator does not achieve the requirement (measured value is inaccurate) |
INCORR |
| When the electric throttle control actuator does not achieve the requirement (temporary prevention) |
PREV |
| When the electric throttle control actuator does not achieve the requirement (impossible) |
IMPOSSI |
| SHIFT POSITION |
Selector lever in any position |
Displayed but not used |
| BRAKE SWITCH 2 |
When brake pedal is not depressed |
Off |
| When brake pedal is depressed |
On |
| BRAKE SWITCH 1 |
When brake pedal is depressed |
Off |
| When brake pedal is not depressed |
On |
| PRESS SENSOR |
When brake pedal is not depressed |
Approx. 0 bar |
| when brake pedal is depressed |
0 - 255 bar |
| ABS |
When ABS function is normal |
NORMAL |
| When ABS function malfunction is detected |
ABNOR |
| ABS MALF |
When ABS function is normal |
NORMAL |
| When ABS function malfunction is detected |
ABNOR |
| EBD |
When EBD function is normal |
NORMAL |
| When EBD function malfunction is detected |
ABNOR |
| ACCELE PEDAL MALF |
When accelerator pedal is normal |
NORMAL |
| When accelerator pedal malfunction is detected |
ABNOR |
| TCS |
When TCS function is normal |
NORMAL |
| When TCS function malfunction is detected |
ABNOR |
| TCS MALF |
When TCS function is normal |
NORMAL |
| When TCS function malfunction is detected |
ABNOR |
| VDC |
When VDC function is normal |
NORMAL |
| When VDC function malfunction is detected |
ABNOR |
| VDC MALF |
When VDC function is normal |
NORMAL |
| When VDC function malfunction is detected |
ABNOR |
| VDC OFF SWITCH |
When VDC OFF switch is OFF |
Off |
| When VDC OFF switch is ON |
On |
| PARKING BRAKE |
When parking brake is inactive |
Displayed but not used |
| When parking brake is active |
Displayed but not used |
| DRV TRQ CTRL MODE |
When correction coefficients are initialized |
INITIAL |
| When correction is executed |
NORMAL |
| When correction is stopped (computing is impossible) |
STOP 1 |
| When correction is stopped (computing is possible) |
STOP 2 |
| When correction is limited |
LIMIT 1 |
| When correction is prohibited |
PROHIBI |
| DRV TRQ CTRL PERMIS 1 |
When correction is permitted (basic requirement) |
PERMIS |
| When correction is not permitted (basic requirement) |
NO PER |
| DRV TRQ CTRL PERMIS 2 |
When correction is permitted (system requirement) |
PERMIS |
| When correction is not permitted (system requirement) |
NO PER |
| DRV TRQ CTRL STOP |
When correction is requested to stop |
REQ |
| When correction is not requested to stop |
NO REQ |
| DRV TRQ CTRL PROHIBIT |
When prohibition of correction is requested |
REQ |
| When prohibition of correction is not requested |
NO REQ |
| AEB |
When Active Engine Brake (corner) function is active |
On |
| When Active Engine Brake (corner) function is inactive |
Off |
| ATC 1 |
When active trace control function is inactive |
Off |
| When active trace control function is active |
On |
| ATC 2 |
When active trace control function is inactive |
Off |
| When active trace control function is active |
On |
| ATC 3 |
When active trace control function is inactive |
Off |
| When active trace control function is active |
On |
| ATC 4 |
When active trace control function is inactive |
Off |
| When active trace control function is active |
On |
| ATC 5 |
When active trace control function is inactive |
Off |
| When active trace control function is active |
On |
| BRAKE HOLD |
When Hill Start Assist function is inactive. |
INACT |
| When Hill Start Assist function is ready. |
ACT |
| When Hill Start Assist function is active. |
RELEA |
| FL TIRE DISP |
When the front LH tire is not displayed on the information display in the combination meter |
DEF |
| When the front LH tire is displayed on the information display in the combination meter |
1 |
| FR TIRE DISP |
When the front RH tire is not displayed on the information display in the combination meter |
DEF |
| When the front RH tire is displayed on the information display in the combination meter |
1 |
| RL TIRE DISP |
When the rear LH tire is not displayed on the information display in the combination meter |
DEF |
| When the rear LH tire is displayed on the information display in the combination meter |
1 |
| RR TIRE DISP |
When the rear RH tire is not displayed on the information display in the combination meter |
DEF |
| When the rear RH tire is displayed on the information display in the combination meter |
1 |
| VEHICLE DISP |
When active ride control (brake) effect is not displayed on the information display in the combination meter |
Off |
| When active ride control (brake) effect is displayed on the information display in the combination meter |
On |
| INTERRUPT DISP |
When interrupt display is not displayed on the information display in the combination meter |
NOREQ |
| When Hill Start Assist function (ready) is displayed on the information display in the combination meter |
HOLD1 |
| When Hill Start Assist function (active) is displayed on the information display in the combination meter |
HOLD2 |
| When Hill Descent Control function is displayed on the information display in the combination meter |
HDC |
| TURN DISP |
When the straight-ahead status is displayed on the information display in the combination meter |
N STEER |
| When the left turning status is displayed on the information display in the combination meter |
LEFT |
| When the right turning status is displayed on the information display in the combination meter |
RIGHT |
| ALC LEVEL |
When Active Lane Control is turned ON. |
Displayed but not used |
| When Active Lane Control is operational or is operating. |
Displayed but not used |
| ALC STATUS |
When Active Lane Control is OFF |
Displayed but not used |
| When Active Lane Control is ON |
Displayed but not used |
| BRAKE HOLD DISP |
When Hill Start Assist function is not displayed on the information display in the combination meter |
INACT |
| When Hill Start Assist function (ready) is displayed on the information display in the combination meter |
ACT |
| When Hill Start Assist function (active) is displayed on the information display in the combination meter |
RELEA |
| ATC DISP |
When the activation of Active Trace Control is not displayed on the information display on the combination meter |
Off |
| When the activation of Active Trace Control is displayed on the information display on the combination meter |
On |
| ARC BRAKE DISP |
When Active Ride Control (Brake) function is not displayed on the information display in the combination meter |
Off |
| When Active Ride Control (Brake) function is displayed on the information display in the combination meter |
On |
| HDC DISP |
When Hill Descent Control function is not displayed on the information display in the combination meter |
Off |
| When Hill Descent Control function is displayed on the information display in the combination meter |
On |