Work Procedure

SAVE TCM DATA (IP CHARACTERISTICS VALUE)
NOTE: Save necessary data stored in TCM in CONSULT according to the following instructions:

With CONSULT
1. Turn ignition switch OFF and wait for 10 seconds.
2. Turn ignition switch ON.
3. Select "Work Support" in "TRANSMISSION".
4. Select "READ IP CHARA - REPLACEMENT TCM".
5. Import data according to the instructions on the CONSULT screen.
  : GO TO 2.
SAVE TCM DATA (VEHICLE SPECIFICATIONS)
With CONSULT
1. Turn ignition switch OFF.
2. Turn ignition switch ON.
3. Select "Re/programming, Configuration".
4. Select "AT/CVT".
  NOTE: If "AT/CVT" is not displayed and TCM data cannot be saved on CONSULT, GO TO 3.
5. Select "Programming".
6. Save TCM data on CONSULT according to the CONSULT display.
  : GO TO 3.
REPLACE TCM
1. Turn ignition switch OFF and wait for 10 seconds.
2. Replace TCM. Refer to "REMOVAL AND INSTALLATION ".
  : GO TO 4.
WRITE TCM DATA (VEHICLE SPECIFICATIONS)
With CONSULT
1. Select "Programming".
2. Perform programming according to the CONSULT display.
  : GO TO 5.
WRITE TCM DATA (IP CHARACTERISTICS VALUE)
NOTE: Write data saved in CONSULT into a new TCM according to the following instructions:

With CONSULT
1. Turn ignition switch OFF and wait for 10 seconds.
2. Turn ignition switch ON.
3. Select "Work Support" in "TRANSMISSION".
4. Select "WRITE IP CHARA - REPLACEMENT TCM".
5. Write data saved in CONSULT in TCM according to the instructions on the CONSULT screen.
  : WORK END