Work Procedure

SAVE TCM DATA
With CONSULT

Save the TCM data according to the CONSULT display.

NOTE: Even when TCM data is not saved in CONSULT, GO TO 2.

:GO TO 2.
REPLACE TRANSMISSION ASSEMBLY
Replace the transmission assembly. Refer to "REMOVAL AND INSTALLATION ".

:GO TO 3.
PERFORM TCM PROGRAMMING
With CONSULT
1. During programming, maintain the following conditions:
  Ignition switch: ON
  
  Selector lever: P
  
  Engine speed: 0 RPM
  
  ATF temp.: 72°C (161°F) or less
2. Perform programming according to the CONSULT display.
3. After completing the programming, maintain the following conditions and turn ignition switch ON → OFF → ON → OFF.
  Brake pedal: Depressed
  
  Selector lever: R
  
  Accelerator pedal: 2.0/8
  
  ATF temp.: 72°C (161°F) or less
  
  :GO TO 4.
CONFIRM SHIFT POSITION INDICATOR
1. Turn ignition switch ON.
2. Shift the selector lever to P position.
3. Shift the selector lever to P → R → N → D → P, confirm the shift position indicator shows correct shift position.
  :WORK END