Component Function Check

With CONSULT

1. Turn ignition switch ON.
2. Select "P/N POSI SW" in "DATA MONITOR" mode of "ENGINE" using CONSULT. Then check the "P/N POSI SW" signal as per the following conditions.

   Selector lever position	Indication
   N or P position	ON
   Except above position	OFF

   Is the inspection result normal? 

   YES: GO TO 2.

   NO: Proceed to "DIAGNOSIS PROCEDURE ".

1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector and ground as per the following conditions.

   ECM				Condition		Voltage (Approx.)
   +		-
   Connector	Terminal	Connector	Terminal
   F11	69	E16	112	Selector lever	P or N	Battery voltage
   					Except above	0 V

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Proceed to "DIAGNOSIS PROCEDURE ".