LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2014 >> Leaf S >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Electric Converters and Controllers >> EV Control System (Introduction) >> Basic Inspection >> Additional Service When Replacing VCM >> Work Procedure

Work Procedure

  1. SAVE VCM DATA 
    1. Turn off the power and wait at least 90 seconds.
      CAUTION: During this period, never perform vehicle handling such as opening and closing of doors. If some kind of vehicle handling is performed, then wait another 90 seconds or more from the time of the vehicle handling.
    2. Turn power switch ON.
    3. Select "SAVE DATA FOR CPU REPLACE" in "WORK SUPPORT" mode using CONSULT.
    4. Follow the instruction of CONSULT display.
      NOTE: Necessary data in VCM is copied and saved to CONSULT.

      Is operation completed successfully? 

      YES: GO TO 2.

      NO: GO TO  5.

  2. REPLACE VCM 
    1. Turn off the power and wait at least 90 seconds.
      CAUTION: During this period, never perform vehicle handling such as opening and closing of doors. If some kind of vehicle handling is performed, then wait another 90 seconds or more from the time of the vehicle handling.
    2. Replace VCM. Refer to "REMOVAL AND INSTALLATION ".

      : GO TO 3.

  3. PERFORM VCM KEY ID REGISTRATION 

    Refer to "VCM: WORK PROCEDURE ".

    : GO TO 4.

  4. WRITE VCM DATA 
    1. Select "WRITE DATA AFTER REPLACE CPU" in "WORK SUPPORT" mode using CONSULT.
    2. Follow the instruction of CONSULT display.
      NOTE: The data saved by "SAVE DATA FOR CPU REPLACE" is written to VCM.

      Is operation completed successfully? 

      YES: GO TO  9.

      NO: GO TO  7.

  5. REPLACE VCM 
    1. Turn off the power and wait at least 90 seconds.
      CAUTION: During this period, never perform vehicle handling such as opening and closing of doors. If some kind of vehicle handling is performed, then wait another 90 seconds or more from the time of the vehicle handling.
    2. Replace VCM. Refer to "REMOVAL AND INSTALLATION ".

      : GO TO 6.

  6. PERFORM VCM KEY ID REGISTRATION 

    Refer to "VCM: WORK PROCEDURE ".

    : GO TO 7.

  7. WRITE VIN DATA 

    Perform "WORK PROCEDURE ".

    : GO TO 8.

  8. LI-ION BATTERY ID REGISTRATION 

    Refer to "Li-ion Battery Registration Operation Manual".

    : GO TO 9.

  9. PERFORM ACCELERATE PEDAL CLOSED POSITION LEARNING 

    Perform "WORK PROCEDURE ".

    : GO TO 10.

  10. SET VCM TIMER 

    Models with navigation system: Perform "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL: WORK PROCEDURE " (Navigation without BOSE) or "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL: WORK PROCEDURE " (Navigation with BOSE).

    Models without navigation system: Set the combination meter clock right. Refer to "INFORMATION DISPLAY: SYSTEM DESCRIPTION ".

    : GO TO 11.

  11. CHECK DTC 
    1. Turn off the power and wait at least 90 seconds.
      CAUTION: During this period, never perform vehicle handling such as opening and closing of doors. If some kind of vehicle handling is performed, then wait another 90 seconds or more from the time of the vehicle handling.
    2. Turn power switch ON.
    3. Check DTC. If DTC is displayed, erase it.

      : END

scientia non olet · About LEMON Manuals