Diagnosis Procedure
- CHECK APP SENSOR 1 POWER SUPPLY
- Turn ignition switch OFF.
- Disconnect accelerator pedal position (APP) sensor harness connector.
- Turn ignition switch ON.
- Check the voltage between APP sensor harness connector and ground.
+ - Voltage (Approx.) APP sensor Connector Terminal E101 4 Ground 5 V Is the inspection result normal?
YES: GO TO 3.
NO: GO TO 2.
- CHECK APP SENSOR 1 POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check the continuity between APP sensor harness connector and ECM harness connector.
+ - Continuity APP sensor ECM Connector Terminal Connector Terminal E101 4 E18 101 Existed - Also check harness for short to ground.
Is the inspection result normal?
YES: Perform the trouble diagnosis for power supply circuit.
NO: Repair or replace error-detected parts.
- CHECK APP SENSOR 1 GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check the continuity between APP sensor harness connector and ECM harness connector.
+ - Continuity APP sensor ECM Connector Terminal Connector Terminal E101 2 E18 105 Existed - Also check harness for short to power.
Is the inspection result normal?
YES: GO TO 4.
NO: Repair or replace error-detected parts.
- CHECK APP SENSOR INPUT SIGNAL CIRCUIT
- Check the continuity between APP sensor harness connector and ECM harness connector.
+ - Continuity APP sensor ECM Connector Terminal Connector Terminal E101 3 E18 102 Existed - Also check harness for short to ground and to power.
Is the inspection result normal?
YES: GO TO 5.
NO: Repair or replace error-detected parts.
- Check the continuity between APP sensor harness connector and ECM harness connector.
- CHECK APP SENSOR
Check the APP sensor. Refer to "COMPONENT INSPECTION ".
Is the inspection result normal?
YES: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".
NO: Replace accelerator pedal assembly. Refer to "EXPLODED VIEW ".