LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2014 >> Juke S, 4WD >> Repair and Diagnosis >> Quick Lookups >> Common Specs & Procedures >> Specifications Index

Specifications Index

JUKE SPECIFICATIONS INDEX

System Specification/Procedure
Air Conditioning
  Service SERVICE DATA AND SPECIFICATIONS (SDS)
  Torque See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION .
Axle Nut/Hub Bearing Bolts
  Front Axle Nuts & Hub Bearing Bolts Front Axle Nuts: 133-136 Ft. lbs. (180-185 N.m)
Front Hub Bearing Bolts: 65 Ft. lbs. (88.3 N.m)
  Rear Axle Nuts (AWD) & Hub Bearing Bolts Rear Axle Nuts: 92 Ft. lbs. (125 N.m)
Rear Hub Bearing Bolts: 65 Ft. lbs. (88.3 N.m)
Battery BATTERY
Brakes
  Bleeding Sequence BLEEDING BRAKE SYSTEM
  Disc Brakes
    Front FRONT DISC BRAKE
    Rear REAR DISC BRAKE
  Torque
    Front See Torque Specifications in text and applicable figures under FRONT DISC BRAKE .
    Rear See Torque Specifications in text and applicable figures under REAR DISC BRAKE .
Charging
  Alternator ALTERNATOR
  Torque See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION
Drive Belts
  Adjustment Vehicle is equipped with automatic tensioner.
  Belt Routing DRIVE BELT
Engine Cooling
  General Service Specifications SERVICE DATA AND SPECIFICATIONS (SDS)
  Radiator Cap Pressure 11-14 psi (78-98 kPa, 0.8-1.0 kg/cm2 )
  Thermostat R & I THERMOSTAT
  Water Pump R & I WATER PUMP
Engine Mechanical
  Compression COMPRESSION PRESSURE
  Oil Pressure
    @ Idle 13.1 psi (90 kPa, 0.92 kg/cm2) or more.
    @ 2000 RPM 37.7 psi (260 kPa, 2.65 kg/cm2) or more.
  Overhaul SERVICE DATA AND SPECIFICATIONS (SDS)
  Torque See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION .
Fluid Specifications See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button.
Flywheel/Flex Plate Torque
  Automatic Transmission 80 Ft. lbs. (108 N.m)
  Manual Transmission 80 Ft. lbs. (108 N.m)
Fuel System
  Fuel Pressure Release Procedure FUEL PRESSURE RELEASE
  Fuel Pressure At Idle: Approximately 73 psi (500 kPa, 5.1 kg/cm2 )
  Fuel Pressure Test Procedure FUEL PRESSURE CHECK
  Fuel Filter Location Located In Tank
  Fuel Filter R & I FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY
Ignition
  Firing Order & Cylinder Identification FIRING ORDER & CYLINDER IDENTIFICATION
  Ignition Wires (Resistance) Engine has coil-on-plug ignition.
  Ignition Wires (Routing) Engine has coil-on-plug ignition.
  Spark Plugs SPARK PLUG
Tightening Torque: 14 ft. Lbs. (19.6 N.m)
Starting
  Starter STARTER MOTOR
  Torque See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION .
Wheel Alignment
  Adjustment Specifications
    Front WHEEL ALIGNMENT
    Rear
      2WD WHEEL ALIGNMENT for 2WD
      AWD WHEEL ALIGNMENT for AWD
  Torque
    Front See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION .
    Rear
      2WD See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION .
      AWD See Torque Specifications in text and applicable figures under REMOVAL AND INSTALLATION .
Wheel & Tire
  Wheel Lug Nut Torque 80 Ft. lbs. (108 N.m, 11 kg.m.)
How To Use Nissan Service Information
  Includes:
Standard Bolt Torque
Symbol Identification
General Connector Info
GENERAL INFORMATION