M/T NEUTRAL POSITION LEARNING: Special Repair Requirement

WARNING: This page is about a different car, the 2013 Nissan 370Z. However, it is still accessible from the selected car via links, so may be relevant.

START
Do you have CONSULT?

Do you have CONSULT?

YES: GO TO 2.

NO: GO TO 3.
PERFORM M/T NEUTRAL POSITION LEARNING
With CONSULT
1. Check that there is no sticking when shifting shift lever to the neutral position.
2. Turn ignition switch ON.
3. Select "M/T NEUTRAL POS LEARN" in "WORK SUPPORT" mode with CONSULT.
4. Touch "Start" and wait a few seconds.
  NOTE: Never touch shift lever. Otherwise learning may not complete normally.
5. Make sure the "COMPLETE" is displayed on CONSULT screen.
  NOTE: If "INCMP" is displayed, return to step 1 and repeat the procedures again.
  
  : END
PERFORM M/T NEUTRAL POSITION LEARNING
Without CONSULT
NOTE:
- It is better to count the time accurately with a clock.
- It is impossible to switch the learning mode when a clutch interlock switch circuit has a malfunction.
1. Check that there is no sticking when shifting shift lever to the neutral position.
2. Turn ignition switch ON and wait 5 seconds.
3. Within 5 seconds repeat the following operation 3 times. Fully depress and fully release clutch pedal while pressing and holding S-MODE switch.
4. Wait 3 seconds while S-MODE switch is released.
5. Wait 5 seconds while pressing S-MODE switch.
6. Wait 3 seconds while S-MODE switch is released.
7. Within 5 seconds repeat the following operation 5 times. Fully depress and fully release clutch pedal while pressing and holding S-MODE switch.
  ECM starts M/T Neutral Position Learning.
  
  NOTE: Never touch shift lever. Otherwise learning may not complete normally.
  
  Fig 1: Ignition Switch Blinking Pattern
  Courtesy of NISSAN NORTH AMERICA, INC.
8. Shift position indicator on combination meter blinks for 5 seconds when the leaning is complete.
  NOTE: If shift position indicator does not blink or blinks continuously, return to step 1 and repeat the procedures again.
  
  : END