Work procedure

Check the amount of engine oil. Replenish if necessary. Refer to "INSPECTION ".
Check for leak of the CVT fluid. Refer to "INSPECTION ".
Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80°C (122 to 176°F).
Be sure to apply the parking brake and block the tires.
Start the engine, depress the brake pedal and shift the selector lever to the "D" Position.
While depressing the brake pedal, depress the accelerator pedal gradually.
Read the stall speed quickly. Then, release your foot from the accelerator pedal quickly.
CAUTION: Never depress the accelerator pedal for 5 seconds or more during the test.

Stall speed: "STALL SPEED "
Shift the selector lever to the "N" position.
Cool the CVT fluid.
CAUTION: Run the engine with the idle speed for at least 1 minute.
Shift the selector lever to the "R" Position and perform Step 6 to Step 9 again.

RESULT OF INSPECTION

Stall speed	"D" position	"R" position	possible cause
	H	O	Forward clutch
	O	H	Reverse brake
	L	L	Engine and torque converter one-way clutch Accelerator pedal position sensor
	H	H	Line pressure low primary pulley Secondary pulley Steel belt
O: Stall speed within standard value position. H: Stall speed is higher than standard value. L: Stall speed is lower than standard value.