Power Supply Position Change Table By Push-Button Ignition Switch Operation
The power supply position changing operation can be performed with the following operations.
NOTE:
- When an Intelligent Key is within the detection area of inside key antenna and when it is inserted to the key slot, it is equivalent to the operations below.
- When starting the engine, the BCM checks the following conditions and then changes the power supply position.
- Brake pedal operating condition
- Selector lever position
- Vehicle speed
Vehicle speed: less than 4 km/h (2.5 MPH)
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency | |||
|---|---|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||||
| LOCK(1) → ACC | - | Not depressed | 1 | ||
| LOCK(1) → ACC → ON | - | Not depressed | 2 | ||
| LOCK(1) → ACC → ON → OFF | - | Not depressed | 3 | ||
| LOCK(1) → START ACC → START ON → START |
P or N position | Depressed | 1 | ||
| Engine is running → OFF | - | - | 1 | ||
|
|||||
- Closing door
- Opening door
- Door is locked using door request switch
- Door is locked using Intelligent Key
The power supply position shifts to "ACC" when the push-button ignition switch (push switch) is pushed at "LOCK".
Vehicle speed: 4 km/h (2.5 MPH) or more
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency | |
|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||
| Engine is running → ACC | - | - | Emergency stop operation |
| Engine stall return operation while driving | N position | Not depressed | 1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.