LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2013 >> Leaf SL >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System >> DTC/Circuit Diagnosis >> DTC C1115: Wheel Sensor >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

  1. PRECONDITIONING 

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn power switch OFF and wait at least 10 seconds before conducting the next test.

    : GO TO  2.

  2. CHECK DTC DETECTION 

    With CONSULT

    1. Set the vehicle to READY.
    2. Drive the vehicle at approx. 30 km/h (19 MPH) or more for approx. 1 minute.
    3. Stop the vehicle.
    4. Turn the power switch OFF → ON.
      CAUTION:
      • Be sure to wait of 10 seconds after turning power switch OFF or ON.
      • Set the vehicle to READY.
    5. Repeat step 4 two or more times.
    6. Perform self-diagnosis for "ABS".

    Is DTC "C1115" detected? 

    YES: Proceed to "DIAGNOSIS PROCEDURE ".

    NO: INSPECTION END

scientia non olet · About LEMON Manuals