LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2013 >> Juke SL, 4WD >> Repair and Diagnosis >> Transmission >> Transfer Case >> System Description >> Diagnosis System (AWD Control Module) >> CONSULT Function >> Active Test

Active Test

Use this mode to determine and identify the details of a malfunction based on self-diagnostic results or data monitor. AWD control module gives drive signal to actuator with receiving command from CONSULT to check operation of actuator.

Test item Condition Description
SOLENOID LEFT
  • Vehicle stopped
  • Engine running
  • No DTC detected
 Change command current value to AWD solenoid (left), and then change driving mode. (Monitor value is normal if it is within approx. ±10% of command value.)
  • Qu: Increase current value in increments of 0.2 A
  • Qd: Decrease current value in increments of 0.2 A
  • UP: Increase current value in increments of 0.02 A
  • DOWN: Decrease current value in increments of 0.02 A
SOLENOID RIGHT
  • Vehicle stopped
  • Engine running
  • No DTC detected
 Change command current value to AWD solenoid (right), and then change driving mode. (Monitor value is normal if it is within approx. ±10% of command value.)
  • Qu: Increase current value in increments of 0.2 A
  • Qd: Decrease current value in increments of 0.2 A
  • UP: Increase current value in increments of 0.02 A
  • DOWN: Decrease current value in increments of 0.02 A
CAUTION: Never energize continuously for a long time.
scientia non olet · About LEMON Manuals