LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2013 >> Juke SL, 4WD >> Repair and Diagnosis >> Transmission >> Transfer Case >> Removal And Installation >> AWD Control Module >> Removal and Installation >> Removal

Removal and Installation: Removal

  1. Turn the ignition switch OFF.
  2. Remove front seat (left side). Refer to "REMOVAL AND INSTALLATION ".
  3. Remove dash side finisher (left side). Refer to "DASH SIDE FINISHER: REMOVAL AND INSTALLATION ".
  4. Remove front and rear kicking plate inner. Refer to "KICKING PLATE INNER: REMOVAL AND INSTALLATION ".
  5. Remove rear seat cushion. Refer to "SEAT CUSHION: REMOVAL AND INSTALLATION ".
  6. Remove outer anchor of front seat belt (passenger side). Refer to "EXPLODED VIEW ".
  7. Remove harness clip.
  8. Turn floor carpet. Refer to "REMOVAL AND INSTALLATION ".
  9. Disconnect AWD control module harness connector.
  10. Remove AWD control module mounting nuts.
  11. Remove AWD control module.
scientia non olet · About LEMON Manuals