LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2013 >> Juke SL, 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P1217 To P2263 >> DTC P1553: Battery Current Sensor >> Component Inspection

Component Inspection

  1. CHECK BATTERY CURRENT SENSOR 
    1. Turn ignition switch OFF.
    2. Reconnect harness connectors disconnected.
    3. Disconnect battery negative cable.
    4. Install jumper cable between battery negative terminal and body ground.
    5. Turn ignition switch ON.
    6. Check the voltage between ECM harness connector and ground.
      Fig 1: Installing Jumper Cable Between Battery Negative Terminal And Body Ground
      G08690401Courtesy of NISSAN NORTH AMERICA, INC.
      ECM Voltage (Approx.)
      Connector + -
      Terminal
      F26 80 87 2.5 V

      Before measuring the terminal voltage, confirm that the battery is fully charged. Refer to "HOW TO HANDLE BATTERY ".

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace battery negative cable assembly. Refer to "EXPLODED VIEW ".

scientia non olet · About LEMON Manuals