DTC Confirmation Procedure: Notes

CAUTION: Never remove fuel filler cap during the DTC Confirmation Procedure.

NOTE:

Make sure that EVAP hose are connected to EVAP canister purge volume control solenoid valve properly.
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

Perform "DTC WORK SUPPORT" when the fuel level is between 1/4 and 3/4 full, and vehicle is placed on flat level surface.
Open engine hood before conducting the following procedure.

WITH CONSULT

Tighten fuel filler cap securely until reteaching sound is heard.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
Make sure that the following conditions are met.
COOLAN TEMP/S: 0 - 70°C (32 - 158°F)

INT/A TEMP SE: 0 - 60°C (32 - 140°F)
Select "EVAP SML LEAK P0442/P1442" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT.
Follow the instruction displayed.

NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT screen, go to "BASIC INSPECTION ".
Make sure that "OK" is displayed.
If "NG" is displayed, select "SELF-DIAG RESULTS" mode with CONSULT and make sure that "EVAP GROSS LEAK [P0455]" is displayed. If it is displayed, refer to "DIAGNOSIS PROCEDURE ".

If P0442 is displayed, perform Diagnostic Procedure for DTC P0442, "DIAGNOSIS PROCEDURE ".