DTC Confirmation Procedure
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
WITH CONSULT
- Turn ignition switch ON.
- Select "P/N POSI SW" in "DATA MONITOR" mode with CONSULT. Then check the "P/N POSI SW" signal under the following conditions.
Position (Selector lever) Known-good signal N or P position (CVT)
Neutral position (M/T)ON Except above OFF If NG, go to "DIAGNOSIS PROCEDURE ".
If OK, go to following step.
- Select "DATA MONITOR" mode with CONSULT.
- Start engine and warm it up to normal operating temperature.
- Maintain the following conditions for at least 60 consecutive seconds.
ENG SPEED More than 1, 300 rpm COOLAN TEMP/S More than 70°C (158°F) B/FUEL SCHDL 2.1 - 31.8 msec VHCL SPEED SE More than 64km/h (29 MPH) Selector lever Suitable position - Check 1st trip DTC.
- If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".