Removal and Installation: Installation

Installation is the reverse order of removal.

• Apply grease Molykote M77 to contact surface between wheel hub and drive shaft. Use sufficient grease to completely coat contact area.

Fig 1: Identifying Grease Applying Area Between Wheel Hub And Drive Shaft

Courtesy of NISSAN NORTH AMERICA, INC.

• When installing disc rotor on wheel hub and bearing assembly, align the marks.

  (When not using the alignment mark, refer to DISASSEMBLY AND ASSEMBLY OF BRAKE CALIPER ASSEMBLY .)

  Fig 2: Identifying Alignment Marks On Disc Rotor And Wheel Hub

  Courtesy of NISSAN NORTH AMERICA, INC.
• Tighten wheel nuts to specification. Refer to ADJUSTMENT .
• Perform the final tightening of each of parts under unladen conditions, which were removed when removing wheel hub and bearing assembly and steering knuckle. Check the wheel alignment. Refer to WHEEL ALIGNMENT INSPECTION .