LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Sentra SE-R >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System - DTCS P0603 To P2A03 (Qr25DE) >> DTC P2138: App Sensor >> Component Inspection >> Accelerator Pedal Position Sensor

Accelerator Pedal Position Sensor

  1. Reconnect all harness connectors disconnected.
  2. Turn ignition switch ON.
  3. Check voltage between ECM terminals 81 (APP sensor 1 signal), 82 (APP sensor 2 signal) and ground under the following conditions.
    Terminal Accelerator pedal Voltage
    81 (Accelerator pedal position sensor 1) Fully released 0.6 - 0.9 V
    Fully depressed 3.9 - 4.7 V
    82 (Accelerator pedal position sensor 2) Fully released 0.3 - 0.6 V
    Fully depressed 1.95 - 2.4 V
    Fig 1: Checking Voltage Between ECM Harness Connector Terminals 81, 82 And Ground
    G04926200Courtesy of NISSAN NORTH AMERICA, INC.
  4. If NG, replace accelerator pedal assembly. Refer to , "REMOVAL AND INSTALLATION ".
scientia non olet · About LEMON Manuals