Component Inspection

CHECK THROTTLE POSITION SENSOR

Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Perform "THROTTLE VALVE CLOSED POSITION LEARNING: SPECIAL REPAIR REQUIREMENT ".
Turn ignition switch ON.
Set selector lever to the D position.

Check the voltage between ECM harness connector terminals.

ECM				Condition		Voltage
+		-
Connector	Terminal	Connector	Terminal
F8	37 TP sensor 1 signal)	F8	36 (Sensor ground)	Accelerator pedal	Fully released	More than 0.36 V
	37 TP sensor 1 signal)				Fully depressed	Less than 4.75 V
	38 (TP sensor 2 signal)				Fully released	Less than 4.75 V
	38 (TP sensor 2 signal)				Fully depressed	More than 0.36 V

Is the inspection result normal?

YES: INSPECTION END

NO: GO TO 2.

REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
Replace electric throttle control actuator. Refer to "REMOVAL AND INSTALLATION ".

: INSPECTION END