Diagnosis Procedure

WARNING: This page is about a different car, the 2011 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

CHECK PUSH-BUTTON IGNITION SWITCH INPUT SIGNAL

Turn ignition switch OFF.
Disconnect push-button ignition switch connector.

Check voltage between push-button ignition switch harness connector and ground.

VOLTAGE REFERENCE CHART

(+)		(-)	Voltage (V) (Approx.)
Push-button ignition switch
Connector	Terminal
M101	4	Ground	9 - 16

Is the inspection result normal?

YES: Go to 4.

NO: Go to 2.

CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT

Disconnect BCM connector and IPDM E/R connector.

Check continuity between push-button ignition switch harness connector and BCM harness connector.

CONTINUITY REFERENCE CHART

Push-button ignition switch		BCM		Continuity
Connector	Terminal	Connector	Terminal	Continuity
M101	4	M124	76	Existed

Check continuity between push-button ignition switch harness connector and ground.

CONTINUITY REFERENCE CHART

Push-button ignition switch		Ground	Continuity
Connector	Terminal
M101	4		Not existed

Is the inspection result normal?

YES: Go to 3.

NO: Repair or replace harness.

REPLACE BCM
1. Replace BCM. Refer to "REMOVAL AND INSTALLATION ".
2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.
  INSPECTION END

CHECK PUSH-BUTTON IGNITION SWITCH GROUND CIRCUIT

Check continuity between push-button ignition switch harness connector and ground.

CONTINUITY REFERENCE CHART

Push-button ignition switch		Ground	Continuity
Connector	Terminal
M101	1		Existed

Is the inspection result normal?

YES: Go to 5.

NO: Repair or replace harness.

CHECK PUSH-BUTTON IGNITION SWITCH
Refer to "COMPONENT INSPECTION ".

Is the inspection result normal?

YES: Go to 6.

NO: Replace push-button ignition switch. Refer to "REMOVAL AND INSTALLATION ".
CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".

INSPECTION END