Component Inspection

CHECK THROTTLE POSITION SENSOR

Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Perform "WORK PROCEDURE ".
Turn ignition switch ON.
Set selector lever to D position.

Check the voltage between ECM harness connector terminals under the following conditions.

ECM			Condition		Voltage
Connector	+	-
Connector	Terminal	Terminal
F7	22 (TP sensor 1 signal)	19 (Sensor ground)	Accelerator pedal	Fully released	More than 0.36 V
	22 (TP sensor 1 signal)			Fully depressed	Less than 4.75 V
	23 (TP sensor 2 signal)			Fully released	Less than 4.75 V
	23 (TP sensor 2 signal)			Fully depressed	More than 0.36 V

Is the inspection result normal?

YES: INSPECTION END

NO: Replace electric throttle control actuator. Refer to "EXPLODED VIEW ".