How To Set
WARNING: This page is about a different car, the 2011 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- Starts on board self-diagnosis STEP 5 mode (Each sensor recognition temperature check; "51" or "52" is indicated on front A/C control display).
- Press fan switch (up: +) and check that "61" is indicated on front A/C control display.
- After approximately 3 seconds, the temperature setting trimmer (rear) can be available.
- The indication will be changed by "5" ("1") in range of -3.0°C (-6°F) to +3.0°C (6°F) by pressing the temperature control switch (passenger side) each time. Press temperature control switch (passenger side) ( ) to increase the set temperature, and press temperature control switch (passenger side) ( ) to decrease the set temperature. When balance setting is minus, A/C switch indicator is turned ON.
Models for Canada
DISPLAY REFERENCE
| Display | Correction (°C) |
|---|---|
| 30 | +3.0 |
| 25 | +2.5 |
| 20 | +2.0 |
| 15 | +1.5 |
| 10 | +1.0 |
| 5 | +0.5 |
| 0 | 0 (Initial setting) |
| 5 | -0.5 |
| 10 | -1.0 |
| 15 | -1.5 |
| 20 | -2.0 |
| 25 | -2.5 |
| 30 | -3.0 |
Models for USA
DISPLAY REFERENCE
| Display | Correction (°F) |
|---|---|
| 6 | +6 |
| 5 | +5 |
| 4 | +4 |
| 3 | +3 |
| 2 | +2 |
| 1 | +1 |
| 0 | 0 (Initial setting) |
| 1 | -1 |
| 2 | -2 |
| 3 | -3 |
| 4 | -4 |
| 5 | -5 |
| 6 | -6 |
| : A/C switch indicator | |
NOTE:
- When -3°C (-6°F) is selected on the temperature setting set as 25°C (75°F), the temperature controlled by A/C auto amp. is 25°C (75°F) - 3°C (6°F) = 22.0°C (69°F), and then the temperature becomes lower than the temperature setting.
- When the battery cable is disconnected from the negative terminal or when the battery voltage becomes 10 V or less, the setting of the difference between the set temperature and control temperature may be cancelled.