How To Set
WARNING: This page is about a different car, the 2011 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- Starts on board self-diagnosis STEP 5 mode (Each sensor recognition temperature check; "51" or "52" is indicated on front A/C control display).
- Press fan switch (up: +) three times and check that "8" is indicated on front A/C control display.
- After approximately 3 seconds, the exhaust gas/outside odor detecting sensor sensitivity adjustment function can be available.
- Press A/C switch or AUTO intake switch to select the setting as per the following.SWITCH REFERENCE CHART
Switch Switch indicator Setting A/C switch ON When AUTO intake switch is turned ON, A/C switch is also turned ON in synchronization with AUTO intake switch. (Initial setting)
Control of the AUTO intake switch is functional even when the A/C switch is turned OFF.OFF When AUTO intake switch is turned ON, A/C switch is not turned ON in synchronization with AUTO intake switch.
Control of the AUTO intake switch is functional even when A/C switch is turned OFF.AUTO intake switch ON AUTO intake switch can be turned ON when A/C switch is OFF.
When A/C switch is turned OFF while AUTO intake switch is ON, AUTO intake switch is not turned OFF in synchronization with A/C switch. (Initial setting)OFF AUTO intake switch can not be turned ON when A/C switch is OFF.
When A/C switch is turned OFF while AUTO intake switch is ON, AUTO intake switch is turned OFF in synchronization with A/C switch.NOTE: When the battery cable is disconnected from the negative terminal or when the battery voltage becomes 10 V or less, the AUTO intake switch interlocking movement change function setting may be cancelled.