Input Signal And Output Signal

WARNING: This page is about a different car, the 2011 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Major signal transmission between each unit via communication lines is shown in the following table.

INPUT SIGNAL AND OUTPUT SIGNAL REFERENCE CHART

Component

Signal description

Yaw rate/side G sensor

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via communication line⁽¹⁾.

Yaw rate signal
Side G sensor signal

ECM

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.

Acceleration pedal position signal
Engine speed signal

Mainly receives the following signals from ABS actuator and electric unit (control unit) via CAN communication.

Target throttle position signal

TCM

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.

Shift position signal
Current gear position signal
P range signal
R range signal
N range signal

Steering angle sensor

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.

Steering angle sensor signal

Combination meter

Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.

Brake fluid level switch signal

Mainly receives the following signals from ABS actuator and electric unit (control unit) via CAN communication.

VDC warning lamp signal
VDC OFF indicator lamp signal

⁽¹⁾	Communication line between yaw rate/side G sensor and ABS actuator and electric unit (control unit)