Inspection Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK BATTERY TERMINALS CONNECTION

   Check if battery terminals are clean and tight.

   Is the inspection result normal? 

   YES: GO TO 2.

   NO: Repair battery terminals connection.

2. CHECK FUSE

   Check for blown fuse and fusible link.

   Unit	Power source (Power supply terminals)	Fuse or Fusible Link
   Generator	Battery (terminal 3)	Fuse 26
   	Battery (terminal 1)	Fusible Link A
   Combination meter	Ignition switch ON (terminal 2)	Fuse 12

   Is the fuse or fusible link blown? 

   YES: Replace the blown fuse or fusible link after repairing the affected circuit.

   NO: GO TO 3.

3. CHECK GENERATOR GROUND TERMINAL CONNECTION

   Verify connector E206 terminal 5 (generator ground harness) is clean and tight.

   Is the inspection result normal? 

   YES: GO TO 4.

   NO: Repair connection.

4. CHECK DRIVE BELT TENSION

   Check drive belt tension. Refer to "CHECKING DRIVE BELTS " (VQ40DE) OR "CHECKING DRIVE BELTS " (VK56DE).

   Is the inspection result normal? 

   YES: Inspection End.

   NO: Repair as needed.