Work Procedure

SAVE VCM DATA
1. Turn off the power and wait at least 20 seconds.
2. Turn power switch ON.
3. Select "SAVE DATA FOR CPU REPLACE" in "WORK SUPPORT" mode using CONSULT.
4. Follow the instruction of CONSULT display.
  NOTE: Necessary data in VCM is copied and saved to CONSULT.
  
  Is operation completed successfully?
  
  YES: GO TO 2.
  
  NO: GO TO 5.
REPLACE VCM
1. Turn off the power and wait at least 20 seconds.
2. Replace VCM. Refer to "REMOVAL AND INSTALLATION ".
  GO TO 3.
PERFORM VCM KEY ID REGISTRATION
Refer to "VCM: WORK PROCEDURE ".

GO TO 4.
WRITE VCM DATA
1. Select "WRITE DATA AFTER REPLACE CPU" in "WORK SUPPORT" mode using CONSULT.
2. Follow the instruction of CONSULT display.
  NOTE: The data saved by "SAVE DATA FOR CPU REPLACE" is written to VCM.
  
  Is operation completed successfully?
  
  YES: GO TO 9.
  
  NO: GO TO 7.
REPLACE VCM
1. Turn off the power and wait at least 20 seconds.
2. Replace VCM. Refer to "REMOVAL AND INSTALLATION ".
  GO TO 6.
PERFORM VCM KEY ID REGISTRATION
Refer to "VCM: WORK PROCEDURE ".

GO TO 7.
WRITE VIN DATA
Perform "WORK PROCEDURE ".

GO TO 8.
LI-ION BATTERY ID REGISTRATION
Refer to "Li-ion Battery Registration Operation Manual".

GO TO 9.
PERFORM ACCELERATE PEDAL CLOSED POSITION LEARNING
Perform "WORK PROCEDURE ".

GO TO 10.
SET VCM TIMER
Refer to "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL: WORK PROCEDURE ".

GO TO 11.
CHECK DTC
1. Turn off the power and wait at least 20 seconds.
2. Turn power switch ON.
3. Check DTC. If DTC is displayed, erase it.
  END